Casio Edifice EQB-900DB-2AER User Manual

Using the Watch in a Medical Facility
or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where auto signal
receive or connection with a phone may cause
problems, you can perform the procedure
below to disable it. To re-enable auto time
adjustment, perform the same operation
again.
1.
Y On the Home Screen, tap the “CASIO
WATCH+” icon.
2.
X Hold down (C) for about two seconds.
●
The second hand will move to [R]. Keep
(C) depressed until the second hand
starts moving again and completes one
full revolution, stopping again at [R].
●
The second hand will move from [R] to
e when a connection is established
between the watch and phone.
3.
Y Perform the operation shown on the
phone screen to enable or disable auto
time adjustment.
Unpairing
1.
X If the watch is connected with a phone,
press any button to terminate the
connection.
30
30
After disconnectionConnected
2.
Y On the Home Screen, tap the “CASIO
WATCH+” icon.
3.
Y Perform the operation shown on the
phone screen to unpair.
Note
●
If you are unable to re-pair the watch
with a phone after unpairing them,
use the procedure below to delete
pairing information from the watch
and then perform the pairing
operation again.
A X Pull out the crown to the second
click.
30
Crown
B X Hold down (D) for about five
seconds.
This causes the second hand to
perform one revolution and deletes the
pairing information.
C X Push the crown back in.
After Purchasing Another Phone
You need to perform the pairing operation
whenever you want to establish a Bluetooth
connection with a phone for the first time.
1.
Move the phone to be paired with close to
(within one meter of) the watch.
2.
Y On the Home Screen, tap the “CASIO
WATCH+” icon.
3.
Y Perform the operation shown on the
screen of the phone to be paired with.
●
If a pairing prompt message appears,
perform the operation shown on the
phone screen.
●
When pairing starts, the second hand
will point to [R]. When pairing is
complete, the second hand will move to
e.
Note
●
If your previous phone is near the
watch while you are trying to pair with
a new phone, the watch will pair with
the previous phone, which makes it
impossible to pair with the new
phone. If this happens, delete the
previous pairing information from the
watch. Also, unregister the watch
from the CASIO WATCH+ app of the
phone you will no longer connect
with.
l
Unpairing
Operation Guide 5560
10

Casio Edifice EQB-900DB-2AER Specifications

General

Brand	Casio
Model	Edifice EQB-900DB-2AER
Category	Watch
Language	English