Casio Edifice EQB-900DB-2AER User Manual

Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted in the cases described
below.
—
When battery power is low
Getting ready
Enter the Timer Mode.
l
Navigating Between Modes
30
Timer Mode
Setting the Time
1.
Pull out the crown to the first click.
2.
Rotate the crown to change the
countdown start time setting.
●
The countdown start time can be set in
1-minute units up to 24 hours.
30
Crown
Minutes
Hours
Seconds
24-hour
3.
Push the crown back in.
Note
●
You can set a countdown start time
of 24 hours by aligning the small 24-
hour hand with 24.
Using the Timer
1.
Press (B) to start the countdown.
30
A beeper will sound for 10 seconds to let
you know when the end of a countdown is
reached.
●
To pause an ongoing countdown, press
(B). To reset a paused countdown to the
start time, press (D).
2.
Press any button to stop the tone.
3.
Press (A) twice to return to the
Timekeeping Mode.
Alarm
The watch will beep when the alarm time is
reached.
●
The beeper is muted in the cases described
below.
—
When battery power is low
—
When watch is at Level 2 power saving
l Power Saving
Getting ready
Enter the Alarm Mode.
l
Navigating Between Modes
30
Alarm Mode
Configuring Alarm Settings
1.
Pull out the crown to the first click.
This turns on the alarm.
30
Alarm on
24-hour
Minutes
Hours
Crown
2.
Rotate the crown to change the alarm time
setting.
3.
Push the crown back in.
4.
Press (A) once to return to the Calendar
Mode.
Note
●
A beeper will sound for 10 seconds
to let you know when the alarm time
is reached.
Turning the Alarm On or Off
Press (D) to toggle the alarm between on and
off.
30
30
Alarm offAlarm on
Stopping the Alarm
While the alarm is sounding, press any button
to stop it.
Operation Guide 5560
13

Casio Edifice EQB-900DB-2AER Specifications

General

Brand	Casio
Model	Edifice EQB-900DB-2AER
Category	Watch
Language	English