OTHER SETTINGS
73
Changing the Date and Time Setting
Use the following procedure to change the date and time
setting.
1.
In the REC mode or PLAY mode, press MENU.
2.
Select the “Set Up” tab, select “Adjust”, and
then rock the controller to the right.
3.
Set the date and the time.
Do this:
Rock the controller up or
down.
Rock the controller left or
right.
To do this:
Change the setting at the
current cursor location
Move the cursor between
settings
4.
Click to register the settings and exit the set-
ting screen.
IMPORTANT!
• You can select any one of the following types of image
as the startup image.
— The camera’s built-in startup image
— A snapshot you recorded with the camera
— A movie you recorded with the camera two sec-
onds or less in length and 200KB or less in size
• The snapshot image or movie that you select as the
startup image is stored in a special memory location
called “startup image memory.” Only one image can
be stored in startup image memory. Selecting a new
startup image overwrites anything that is already
stored in startup image memory. Except for the
camera’s built-in startup image, if you want to return to
a previous startup image, you need to have a separate
copy of that image in the camera’s standard image
storage memory.
To Next Page
Loading...
Need help?
General
