EasyManuals Logo
Home>Casio>Digital Camera>Exilim EX-S10

Casio Exilim EX-S10 User Manual

Casio Exilim EX-S10
167 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #139 background imageLoading...
Page #139 background image
139
Appendix
. Power Supply
Use only the special rechargeable lithium ion battery (NP-60) to power this camera.
Use of any other type of battery is not supported.
The camera does not have a separate battery for the clock. The date and time
settings of the camera are cleared about two days after power is cut off from the
battery. If this happens, be sure to reconfigure these settings after power is
restored (page 128).
. Data Error Precautions
Your digital camera is manufactured using precision digital components. Any of the
following creates the risk of corruption of data in camera memory.
Removing the battery or memory card while the camera is performing some
operation
Removing the battery or memory card while the back lamp is flashing green after
turning off the camera
Disconnecting the USB cable while communication is in progress
Using a battery that is low
Other abnormal operations
Any of the above conditions can cause an error message to appear on the monitor
screen (page 159). Perform the action indicated by the message that appears.
. Operating Environment
Operating Temperature: 0 to 40°C (32 to 104°F)
Operating Humidity: 10 to 85% (non condensation)
Do not place the camera in any of the following locations.
In an area exposed to direct sunlight, or large amounts of moisture or dust
Near an air conditioner or in other areas subjected to extreme temperature or
humidity
Inside of a motor vehicle on a hot day, or in an area subjected to strong vibration
. Condensation
Sudden and extreme temperature changes, such as when the camera is moved from
the outdoors on a cold winter day into a warm room, can cause water droplets called
“condensation” to form on the interior and the exterior of the camera, which creates
the risk of malfunction. To prevent condensation from forming seal the camera in a
plastic bag before changing locations. Then leave the bag sealed to allow the air
inside to naturally change to the same temperature as the air in the new location.
After that, remove the camera from the bag and open the battery cover for a few
hours.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Casio Exilim EX-S10 and is the answer not in the manual?

Casio Exilim EX-S10 Specifications

General IconGeneral
Megapixel10 MP
Camera typeCompact camera
Sensor typeCCD
Image sensor size1/2.3 \
Maximum image resolution3648 x 2736 pixels
Digital zoom4 x
Optical zoom3 x
Focal length range6.3 - 18.9 mm
Digital SLRNo
Built-in flashYes
Power consumption (typical)4.2 W
Focal length (35mm film equivalent)36 - 108 mm
Auto focusing (AF) modescontinuous auto focus, multi point auto focus, spot auto focus
Light meteringCentre-weighted, Spot
ISO sensitivity50, 100, 200, 400, 800, 1600
Light exposure modesAuto
Internal memory11.8 MB
Compatible memory cardsmmc, sd
Video formats supportedMOV
Maximum video resolution848 x 480 pixels
Display diagonal2.7 \
Display resolution (numeric)959 pixels
I/O portsA/V
USB version2.0
Image editingresizing, rotating, trimming
White balanceauto, daylight, Fluorescent, manual, Shade, Tungsten
Camera playbackmovie, single image, slide show
Self-timer delay10 s
Playback zoom (max)8 x
Product colorBlack
Number of batteries supported1
Flash modesauto, Flash off
Weight and Dimensions IconWeight and Dimensions
Depth14.9 mm
Width94 mm
Height54.5 mm
Weight112.5 g

Related product manuals