54
Snapshot Tutorial
• You can specify 5, 10, 20, or 30 as the maximum number of shots for each
continuous shutter operation.
• You can specify anywhere from 1 second up to 10 seconds as the continuous
shutter shooting time, which is the amount of time of the pre-record buffer plus the
amount of time that continuous shutter recording is performed after the shutter
button is pressed all the way. The maximum shooting time depends on the
selected CS speed. You can select a CS speed in the range of 3 to 30 fps.
• You can configure the mode so up to 25 images are pre-recorded to the buffer until
you fully press the shutter button.
• The minimum number of pre-recorded buffer images you can specify is three. Total
recording time depends on the current continuous shutter frames-per-second (fps)
setting.
• Specifying zero for the number of pre-recorded images disables Prerecord CS and
performs High Speed CS only (without pre-recording). Note that the mechanical
shutter is used when shooting with High Speed CS.
. Getting Ready
1. Set the mode dial to t (Auto).
2. Press Õ (Continuous Shutter).
• This will display Š (High Speed CS). If this does
not happen, press Õ again.
3. Press [SET].
4. Use [8] and [2] to select the fourth control
panel option from the bottom (High Speed CS fps).
5. Use [4] and [6] to select the continuous shutter
(CS) speed you want.
6. Use [8] and [2] to select the third control panel
option from the bottom (Max CS shots).
7. Use [4] and [6] to select the maximum number of shots for each
continuous shutter operation.
30 images per second
(30 fps)
You can shoot up to 30 images in 1 second.
3 images per second
(3 fps)
You can shoot up to 10 images over 30 seconds.
3 to 30 fps
Enables specification of the number of CS images recorded per
second.
High Speed CS icon
CS speed
To Next Page
Loading...
Need help?
General
