E-31
The printer can print on roll paper (80 mm or 58 mm wide)* or 80 mm wide formed
sheet paper. When printing on formed sheet paper, use the paper holder (HA-B93PH)
sold separately.
When Using Roll Paper
Installing the Roll Paper
1. Check that the power is off. If the power is on, always make sure to turn it off by
pressing the power key.
2. Press the ridged (
) portions ( ) of
the splash protect cover while spreading
apart the locks on the left and right sides
( ) to disengage them as shown in the
illustration followed by opening the
splash protect cover ( ).
3. Slide the lock knobs on the left and right
sides of the roll paper holder as shown
in the illustration to align at the FREE
position ( ), and then push up the
ridged (
) portion ( ) to open.
• Please note that the positions of the
lock knobs on the left and right sides
are different.
4. Peel off the seal from the roll paper and
install as shown in the illustration.
*IT-3100M75E prints on 82.55mm width roll paper only.
1
2
3
1
2
Using the Printer
1
3
2
2
1
1
2
1
To Next Page
Loading...
Need help?
General
