Overview and Setup
EN-10
■ Expression Pedal Calibration
When connecting an expression pedal to the
dl EXPRESSION/ASSIGNABLE jack for the first time,
perform the calibration operation below.
1.
Connect an expression pedal to the
dl EXPRESSION/ASSIGNABLE jack.
2.
Hold down the bp^ button until “[FUNCTION]”
appears on the display.
This enters the FUNCTION Mode.
3.
Use the bk U and bl I buttons to display
“PEDAL/WHEEL” and then touch bm ENTER.
4.
Use the bk U and bl I buttons to display
“EXP/ASGN PEDAL” and then touch
bm ENTER.
5.
Use the bk U and bl I buttons to display
“Exp Calibration” and then touch bm ENTER.
This displays “Sure?”. If you want to cancel the operation
at this point, touch bk – here.
6.
Touch bl + to start adjustment.
7.
While “Highest” is displayed, press the top of
the pedal down as far as it will go and then
touch bm ENTER.
8.
While “Lowest” is displayed, press the bottom
of the pedal down as far as it will go and then
touch bm ENTER.
The message “Complete” will appear when the operation
is complete.
9.
To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
Using headphones cuts off output from the built-in speakers,
which means you can practice playing even late at night
without disturbing others.
• Be sure to turn down the volume level before connecting
headphones.
• Headphones do not come with the Digital Piano.
• Use commercially available headphones. See page EN-1
for information about options.
• Do not listen to very high volume output over
headphones for long period. Doing so creates the risk
of hearing damage.
• If you are using headphones that require an adaptor
plug, make sure you do not leave the adaptor plugged
in when you unplug the headphones. If you do, nothing
will sound from the speakers when you play.
■ To output from the speakers while headphones
are connected
While FUNCTION parameter 104 (“Speaker Out”) is enabled
(“On”), sound will be output from the speakers even if
headphones are connected to the PHONES jack. For
information about FUNCTION parameters, see “Configuring
Function Settings (FUNCTION Mode)” (page EN-53).
Using Headphones
co PHONES jacks (Stereo mini jack (3.5mm))
To Next Page
Loading...
Need help?
General
