Overview and Setup
EN-6
1.
Before turning on power, rotate the 2 volume
knob as far as it will go in the direction shown
in the illustration below.
2.
Press the 1P (Power) button to turn on
power.
The message “Welcome” will appear momentarily,
followed by the tone name display. This indicates that the
Digital Piano is ready for use.
• After pressing 1P (Power) to turn on power, do not
press any pedal until the Digital Piano is ready to play
(the tone name display appears).
• Power may not turn on if you press the 1P (Power)
button too lightly. This does not indicate malfunction. If
this happens, apply more pressure when you press the
1P (Power) button.
3.
Use the 2 volume knob to adjust volume.
4.
To turn off power, hold down the 1P (Power)
button until “Bye” appears on the display.
• Pressing the 1P (Power) button to turn off power actually
puts the Digital Piano into a standby state. Minute amounts
of current continue to flow within the Digital Piano in the
standby state. If you do not plan to use the Digital Piano for
a long time or if there is a lightning storm in your area, be
sure to unplug the AC adaptor from the power outlet.
• Turning off power normally causes the tone number and
other settings to return to their initial defaults. You can
enable Auto Resume, which will save most settings when
power is turned off.
• If Auto Resume is disabled, turning off power will initialize
settings, except for those below.
Tuning, LCD contrast, pairing information (Bluetooth
connection logs), expression/assignable pedal type,
expression/assignable pedal calibration, touch button
sensitivity
■ Power On Alert
After about six minutes of non-operation while the Digital
Piano is being powered by its AC adaptor, the Power On Alert
function will cause touch button lights to turn on and off
sequentially to remind you that power is on.
Button lights will return to normal if you touch a button, play
something on the keyboard, or perform some other operation.
To turn off power, hold down the 1P (Power) button until
“Bye” appears on the display.
• Use FUNCTION parameter 107 (“Power On Alert”) to
enable or disable Power On Alert. For information about
FUNCTION parameters, see “Configuring Function
Settings (FUNCTION Mode)” (page EN-53).
• If you are using batteries to power the Digital Piano, power
will turn off automatically after about six minutes of non-
use. See “Auto Power Off” (page EN-6).
■ Adjusting Display Contrast
Use FUNCTION parameter 109 (“LCD Contrast”) to adjust
display contrast. For information about FUNCTION
parameters, see “Configuring Function Settings (FUNCTION
Mode)” (page EN-53).
■ Operation Lock
Operation lock can be used to prevent operational errors
during performances by disabling button operations. For
details, see “Using Operation Lock” (page EN-59).
■ Returning to Initial Factory Defaults
You can use Factory Reset to return the Digital Piano’s stored
data and settings to their initial factory defaults any time you
want. For more information, see “To return all Digital Piano
settings and data to their initial factory defaults (Factory
Reset)” (page EN-60).
■ Auto Power Off
This Digital Piano is designed to turn off automatically to avoid
wasting power after no operation is performed for a preset
amount of time. The Auto Power Off trigger time is about four
hours when power is being supplied by the AC adaptor, or six
minutes under battery power.
• You can disable Auto Power Off to ensure that power does
not turn off automatically during a concert, etc. To disable
Auto Power Off, select “Off” for FUNCTION parameter 106
(“Auto Power Off”). For information about FUNCTION
parameters, see “Configuring Function Settings
(FUNCTION Mode)” (page EN-53).
Turning Power On or Off
To Next Page
Loading...
Need help?
General
