Digital Piano Operations
EN-20
Use the tuning feature when you need to adjust the pitch
slightly to play along with another musical instrument.
• The tuning feature specifies the frequency of the A4 note.
You can set a frequency within the range of 415.5 to
465.9 Hz. The initial default setting is 440.0 Hz.
• You can change the frequency in 0.1 Hz steps.
■ To change the tuning setting
1.
Hold down the bp^ button until “[FUNCTION]”
appears on the display.
This enters the FUNCTION Mode.
2.
Use the bk U and bl I buttons to select the
following menu items in sequence: “SYSTEM”
3 “Master Tuning”.
3.
Use the bk – and bl + buttons, or cm (K1)
knob to change the setting.
• To return to the initial default setting, touch bk – and
bl + at the same time.
4.
To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
You can use the procedure below to raise or lower pitch in
octave units. In the explanation here, we will assume that
layer and split are not being used, and octave shift the
keyboard tone (Upper1 part).
• When layer and/or split is being used, you can specify
separate octave shift settings for each part (Upper1,
Upper2, Lower). For details about the settings of each part,
see “Configuring Layer and Split Settings” (page EN-17).
■ To octave shift the Upper1 part
1.
Disable both layer and split if they are enabled.
• See “To unlayer the keyboard” (page EN-16) and “To
unsplit the keyboard” (page EN-17).
2.
Hold down the bp^ button until “[FUNCTION]”
appears on the display.
This enters the FUNCTION Mode.
3.
Use the bk U and bl I buttons to select the
following menu items in sequence:
“KEYBOARD” 3 “PART OCT SHIFT” 3
“Upper1 Part”.
This displays the Upper1 part octave shift setting screen.
4.
Use the bk – and bl + buttons, or cm (K1)
knob to change the setting.
• You can shift the octave within the range of –2 to +2.
• To return to the initial default setting, touch bk – and
bl + at the same time.
5.
To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
Fine Tuning a Pitch (Tuning) Changing the Pitch in Octave Units (Octave
Shift)
[
FUNCT I ON
]
–
0
+
<
U
pp
e r 1 P a r t
>
To Next Page
Loading...
Need help?
General
