— 5 —
1. PROGRAM LOADING
1-1. Important notice
Flash ROM on the D-PCB contains camera’s operating program and graphic menu. The D-PCB is used in
the models QV-2400UX and QV-2900UX, however, the programs are different. Therefore, the PCB provided
as a spare part cannot be discriminated which program is recorded.
(Or old program may be recorded.)
Be sure to load the program after you replace the D-PCB.
Moreover, when you fail in updating the version of a program with CF card, a program breaks and a camera
cannot be powered, please perform this method for loading program.
(You can upgrade the program by this loading method.)
Note: If QV-2400UX program is loaded onto QV-2900UX, display indicates “NOT715 MOTOR” and the
camera does not function.
1-2. To load the program
1. Turn the camera off and remove the CF card then close the CF cover.
Disconnect the battery and AC adaptor.
2. Connect the PC link cable.
3. Boot transferring program fload.exe.
4. Choose the program data “_romXXXX.bin.”
Notes:
*XXXX is 4-digit number depending upon the program version.
*When loading file is chosen, “loaded XXXXXX bytes” is indicated on Status screen.
5. Choose the transfer speed 115K, 57K or 38K. If an error occurs, choose slower transfer speed.
6. Click Progress button on the fload.exe.
To Next Page
Loading...
Need help?
General
