V-R7000/V-R7100
– 22 –
Device ID
NOTE: When the Main PCB is replaced with a new one, be sure to perform this item.
1
Tap “Device ID”.
Read the Device ID with a scanner, or directly
enter the Device ID.
NOTE: The ports for the USB scanner are USB
Port 2 to USB Port 4 located on the rear
side. Carefully connect or disconnect the
USB scanner.
2
After entering the serial number, tap “Set Device
ID”.
Tap “
” to show the judgment screen, and
then tap the obtained test result.
Reg UUID
NOTE: When the IOC PCB is replaced with a new one, be sure to perform this item.
1
Tap “Reg UUID”.
Tap “UUID set”. Then the new UUID is written to
the IOC PCB.
(At the time when it is tapped, the frame is
painted in blue.)
Tap “
” to show the judgment screen, and
then tap the obtained test result.
Closing the Test Application
1
Tap “Exit”
“Yes”.
Delete the test application related data.
To Next Page
Loading...
Need help?
General
