15
The following Eco Mode settings are available to specify whether priority should be given to
low-power, low-noise operation or to projection brightness.
To select the Eco Mode
1.
Press the [ECO] key.
z This causes “Eco Mode” window to appear on the projection screen.
2.
Use the [W] and [X] keys to select the setting you want.
z If you select “On” here, go to step 3. If you select “Off”, jump to step 4.
3.
Perform the following steps to adjust the “Eco Level” (the balance between
low-power, quiet operation and projection brightness).
4.
To hide the window, press the [ESC] key.
Note
z While “Off” is selected for the Eco Mode setting, you also can specify whether brightness or
color should be given emphasis. For details, see “Image Adjustment 1 3 Eco Off Mode”
(page 20).
Eco Mode (ECO)
On : Enables manual adjustment to balance the needs of low-power, quiet operation and projection
brightness.
Off: Give top priority to projection brightness.
1
Press the [T] key to move the highlighting to the Eco Level.
2
Use the [W] and [X] keys to adjust the Eco Level to the setting you want.
Fewer marks gives higher priority to projection brightness. A greater number gives high
priority to low-power, quiet operation.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
