Casio XJ-V1 User Manual

33
The projector’s firmware (software in the projector flash ROM) can be updated from a computer
connected to the projector’s SERVICE port (USB port for ROM updating) with a USB cable.
To connect the projector’s SERVICE port with a computer’s
USB port
Use a commercially available USB cable to connect the projector’s SERVICE port to the computer’s
USB port.
Use a USB cable with a micro USB plug on one end for connection to the projector’s SERVICE port,
and a plug on the other end with a shape that is compatible with the computer USB port.
Note
z For details about how to update the firmware, see the “Projector Firmware Update Guide”,
which is available at the CASIO website.
The projector can be hung from a ceiling. When doing so, the projector should be turned upside down,
and secured to the ceiling.
For full details, contact the retailer where you purchased the projector.
Important!
z When hanging the projector from a ceiling, make sure that it is at least one meter away from
fire detectors, fire alarms, and other fire protection devices. Locating the projector too close to
a fire protection device creates the risk of mis-operation of the device due to warm air
exhausted from the projector. Also, avoid locating the projector close to fluorescent lights or
other strong light sources. Bright light can shorten the operating range of the remote controller
or even make remote control impossible. When selecting a location for the projector, be sure
to test for proper operation of the remote controller.
z The vertical and horizontal orientation of the projected image is reversed from the normal
configuration when projecting from a projector hung from the ceiling. You need to change the
setup of the projector in order to correct for this. For details, see “Screen Settings 3 Ceiling
Mount” (page 20) under “Setup Menu Settings”.
Updating Firmware
Hanging the Projector from a Ceiling
SERVICE port

Casio XJ-V1 Specifications

General

Matrix size	0.55 \
Number of colors	1.073 billion colors
Native aspect ratio	-
Projection distance	- m
Projection technology	DLP
Contrast ratio (dynamic)	20000:1
Screen size compatibility	30 - 300 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-30 -30 °
Focus	Manual
Offset	72 %
Throw ratio	1.54 - 1.71:1
Optical zoom	1.1 x
Focal length range	- mm
Light source type	Laser/LED hybrid
Service life of light source	20000 h
Full HD	No
Supported graphics resolutions	1200 x 1600, 1680 x 1056
AC (power) in	Yes
Composite video in	0
USB connector type	Micro-USB B
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	37 dB
Noise level (economic mode)	35 dB
Placement	Desktop
Product type	Standard throw projector
Product color	White
Power source	AC
Power consumption (standby)	0.23 W
Power consumption (typical)	150 W
Operating temperature (T-T)	5 - 35 °C
Remote control type	IR

Weight and Dimensions

Width	270 mm
Height	89 mm
Weight	2800 g