5
Operating Instruction for Thermal Imager
1.Introduction
• The Thermal Imager is handheld imaging camera used for predictive maintenance, equipment troubleshooting
and verification.
• Focus the len to the object, Then the thermal and visual images are displayed on the LCD and can be saved to a
Micro SD Memory card.
• Transferring images to a PC is accomplished by removing the SD memory card and connecting it to a PC through
the included card reader, or transfer the images and video stream to the smart device with “Thermoview” apps
installed.
• In addition to the features mentioned above, the Thermal Imager provide video recording and play back
2.Safety Information
• To prevent eye damage and personal injury, do not look into the laser. Do not point laser directly at persons or
animals or indirectly off reflective surfaces.
• Do not disassemble or do a modification to the Thermal Imager.
• Do not point the Thermal Imager (with or without the lens cover) at intensive energy sources, for example devices
that emit laser radiation, or the sun.
• This can have an unwanted effect on the accuracy of the camera. It can also cause damage to the detector in the
Thermal Imager.
• Do not use the Thermal Imager in a temperature higher than 50°C (122°F), lower than -20°C (-4°F), High
temperature or low temperature can cause damage to the Thermal Imager.
• Only use the correct equipment to discharge the battery.
• If you do not use the correct equipment, you can decrease the performance or the life cycle of the battery, If you
do not use the correct equipment, an incorrect flow of current to the battery can occur, This can cause the battery
to become hot, or cause an explosion and injury to persons.
• Do not pull out the battery when the thermal imager is working.
• If you pull out the battery when the thermal imager is working, it may cause the thermal imager work unnormal.
• Do not disassemble or do a modification to the battery.
• The battery contains safety and protection devices which, if they become damaged, can cause the battery to
become hot, or cause an explosion or an ignition.
• If there is a leak from the battery and the fluid gets into your eyes, do not rub your eyes, Flush well with water
and immediately get medical care.
• Do not make holes in the battery with objects, Do not hit the battery with a hammer, Do not step on the battery,
or apply strong impacts or shocks to it.
• Do not put the battery in or near a fire, or in direct sunlight, or other high-temperature locations, Do not solder
directly onto the battery.
• Always charge the battery in the special temperature rang.
• The temperature range through which you can charge the battery is 0 to 50°C (32 to 122°F), If you charge the
battery at temperatures out of this range, it can cause the battery to become hot or to break, It can also decrease
the performance or the life cycle of the battery.
To Next Page
Loading...
Need help?
General
