Jump
Starting
If
your battery has run down, you may want to use
another vehicle and some jumper cables to start your
vehicle. Be sure to
fo”
N
the steps below to do it safely.
ILteries ca..
.wrt
you. They can be _._ingerous
because:
@
They contain acid that can burn you.
They contain gas that can explode or
They contain enough electricity to
ignite.
burn you.
If
you don’t follow these steps exactly, some
or all
of
these things can hurt you.
Notice:
Ignoring these steps could result
in
costly
damage to your vehicle that wouldn’t be covered
by your warranty. Trying
to
start your vehicle
by pushing or pulling
it
won’t work, and
it
could
damage your vehicle.
1.
Check the other vehicle. It must have a 12-volt
battery with a negative ground system.
Notices
If
the other system
isn’t
a
12-volt system
with a negative ground, both vehicles can be
damaged.
2.
Get the vehicles close enough
so
the jumper cables
can reach, but be sure the vehicles aren’t touching
each other.
If
they are, it could cause a ground
connection you don’t want.
You
wouldn’t be able to
start your vehicle, and the bad grounding could
damage the electrical systems.
To avoid the possibility of the vehicles rolling, set
the parking brake firmly on both vehicles involved in
the jump start procedure. Put an automatic
transmission in PARK (P) or a manual transmission
in NEUTRAL before setting the parking brakes.
Notice:
If
you leave your radio on,
it
could be badly
damaged. The repairs wouldn’t be covered by
your warranty.
3.
Turn
off
the ignition on both vehicles. Unplug
unnecessary accessories plugged into the cigarette
lighter or in the accessory power outlet. Turn
off
avoid sparks and help save both batteries. And it
could save your radio!
LL-
--A:-
--A
,I1
I
----
4L-&
-___
l+
,,,JIJ
Th:-
...
;II
LI
it;
lauiu
ai
IU
all
la1
I
‘pa
11
la1
alcil
I
L
I
IGGUGU.
I
I
113
YVIII
5-41
To Next Page
Loading...
Need help?
General
