Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
An arrow on the
instrument panel
cluster will flash in
the direction of the
turn or lane change.
To signal a lane change, raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return
by itself when you release it.
If the arrow flashes faster than normal as you
signal a turn or a lane change, a signal bulb may
be burned out and other drivers won’t see
your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when
you signal a turn, check for burned-out bulbs and
then check the fuse. See Fuses and Circuit
Breakers on page 395.
Turn Signal On Chime
If you leave either one of your turn signals on and
drive more than three-quarters of a mile (1.2 km),
a chime will sound to alert you.
150
To Next Page
Loading...
Need help?
General
