3. Remove the socket by turning it
counterclockwise and pull it out.
4. Pull the old bulb straight out.
5. Push the new bulb into the socket.
6. Push the socket back into the assembly.
Tighten the socket by turning it clockwise.
7. Reinstall the assembly with the two screws.
License Plate Lamp
To replace one of these bulbs, do the following:
1. Turn the lamp assembly counterclockwise and
pull the lamp assembly out of the connector.
2. Pull the old bulb from the lamp assembly,
keeping the bulb straight as you pull it out.
3. Install the new bulb.
4. Reverse Steps 1 through 3 to reinstall the
license plate lamp.
Replacement Bulbs
Exterior Lamp Bulb Number
Back-Up Lamp 921
Front Parking/Turn Signal Lamp 3157NAK
License Plate Lamp 194
Headlamps
High-Beam H9
Low-Beam H11
Sidemarker Lamp 194
Stoplamps, Taillamps, and
Turn Signal Lamp
3057
For replacement bulbs not listed here, contact
your dealer.
346
To Next Page
Loading...
Need help?
General
