Your vehicle has a power driver’s seat. The
control is located on the outboard side of the
seat cushion. To adjust the seat, do any of the
following:
• Move the seat forward or rearward by sliding
the control forward or rearward.
• Raise or lower the front part of the seat
cushion by moving the front of the control
up or down.
• Raise or lower the rear part of the seat
cushion by moving the rear of the control
up or down.
Manual Lumbar
The driver’s seat has manual lumbar. The lever
is located on the outboard side of the seat near
the front of the seat cushion. Lift up on the
lever repeatedly to increase lumbar support.
Push down on the lever repeatedly to decrease
lumbar support.
Driver’s Seat with Manual Lumbar,
Power Seat Control, and Manual Recline shown
9
To Next Page
Loading...
Need help?
General
