Chromalox 2110 User Manual

2110 Temperature Controller
Chromalox 2110
13
Section 4–Adjusting Set Point and Configuration
Load
Alarm
¡F
¡C
Temp
Set
Point
Set Point
Chromalox
¤
2110
Load
Alarm
¡F
¡C
Temp
Set
Point
Set Point
Chromalox
¤
2110
Load
Alarm
°F
°C
Tem p
Set
Point
Set Point
Chromalox
®
2110
Figure 4.3
Figure 4.5
Figure 4.6
Figure 4.4
Figure 4.7
4. Press the or buttons to adjust the value (only the value is dis-
played during adjustment). See Figure 4.7. The new value is set when
the
or button is released.
5. Press and hold the Set Point (
) button and press the button to
advance to the next menu. See Figure 4.8. (Holding the Set Point
( ) button and pressing the button moves through menus in the
opposite direction.)
Repeat steps 4 and 5 through the configuration menus.
Exit Configuration
To exit configuration mode, press and hold both the
and buttons for
three seconds to return to the operation mode.
Note: If no buttons are pressed for three minutes while in user configu-
ration mode, then the controller will exit user configuration and return to
the operation mode.
Load
Alarm
¡F
¡C
Tem p
Set
Point
Set Point
Chromalox
¤
2110
Figure 4.8
Load
Alarm
¡F
¡C
Tem p
Set
Point
Set Point
Chromalox
¤
2110
Load
Alarm
¡F
¡C
Tem p
Set
Point
Set Point
Chromalox
¤
2110
Configuration
continued
Adjust lock
to 458
Move to
next menu
Continue
until SP is
displayed
Adjust the
set point
value
Continue
through the
configuration
menus

Chromalox 2110 Specifications

General

Brand	Chromalox
Model	2110
Category	Temperature Controller
Language	English