1
Note
Use only SFPs have been qualified for use on the management center. Although non-Cisco
SFPs and other Cisco SFPs are allowed, we do not recommend using them because they
have not been tested and validated by Cisco. Cisco TAC may refuse support for any
interoperability problems that result from using an untested SFP transceiver.
Package Contents
The following figure shows the package contents for the 1700, 2700, and 4700. Note that the contents are
subject to change and your exact contents might contain additional or fewer items.
Figure 2: Package Contents
RJ-45 to DP9-RS232 console cable (Cisco part
number 72-3383-XX)
2Chassis1
RJ-45 to RJ-45 Cat 5 Ethernet cable, yellow six
feet long (Cisco part number 72-1482-XX)
4Cisco rail kit (Cisco part number 800-43376-02)3
Two 10-Gb SFP+ transceivers with cables
supported for all models or 25-Gb SFP+
transceivers with cables supported for the 4700
Optional for all models; in package if ordered.
6Cisco Secure Management Center 1700, 2700,
and 4700
This document contains URLs that point to the
product overview, hardware installation guide,
regulatory compliance and safety information
guide, warranty, and licensing pages, and a QR
code that points to the management center
Documentation Portal.
5
Serial Number Locations
The serial number (SN) for the 1700, 2700, and 4700 is printed on the pullout asset card located on the front
panel as shown in the following figure of the 1700.
Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide
4
Overview
Package Contents
To Next Page
Loading...
Need help?
General
