Cisco 2500 Series Deployment Guide

Port Country Priority
−−−− −−−−−−− −−−−−−
1 US 1
1 US 1
The APs that have joined the controller can also be verified by verifying the APs summary on the controller.
Configure both the AP name and the Location of the AP install.
Prime the AP by configuring the controller name and IP address under High Availability.
With this configuration, the AP will join the configured controller as the first preference.
External DHCP Server with DHCP Proxy Disabled
This is a general setup that has been in practice for all Cisco controllers for some deployments. The
configurations are almost the same as noted in the previous, but will have the DHCP Proxy disabled.
The AP−manager interfaces in this scenario point to an external DHCP server.
Note: It is recommended to enable either an internal DHCP server or an external DHCP server.
ip dhcp excluded−address 10.10.11.1 10.10.11.150
!
ip dhcp pool VLAN11

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English