(Cisco Controller)
The show license all command displays the installed licenses.
Note: This license includes a data DTLS functionality.
(Cisco Controller) >show license all
(Cisco Controller) >show license all
License Store: Primary License Storage
StoreIndex: 2 Feature: base−ap−count Version: 1.0
License Type: Permanent
License State: Active, In Use
License Count: 50/50/0
License Priority: Medium
StoreIndex: 3 Feature: data encryption Version: 1.0
License Type: Permanent
License State: Active, In Use
License Count: Non−Counted
License Priority: Medium
License Store: Evaluation License Storage
StoreIndex: 0 Feature: base Version: 1.0
License Type: Evaluation
License State: Active, Not in Use, EULA accepted
Evaluation total period: 8 weeks 4 days
Evaluation period left: 8 weeks 4 days
License Count: Non−Counted
License Priority: Low
StoreIndex: 1 Feature: base−ap−count Version: 1.0
License Type: Evaluation
License State: Inactive
Evaluation total period: 8 weeks 4 days
Evaluation period left: 8 weeks 4 days
License Count: 50/0/0
License Priority: None
(Cisco Controller) >
Enable DTLS in the Cisco 2500 Series Controller
In order to enable DTLS on an AP or particularly on a group of APs, make sure that you have Data
Encryption License installed in the controller. DTLS (Data Encryption) can be enabled on a per AP basis from
the Advanced tab once you select the AP details.
Choose an AP, go to the Advanced tab, and choose the Data Encryption option.