Cisco 2500 Series Deployment Guide

If multiple Ethernet ports on a Cisco 2500 Series Wireless Controller are uplinked to an infrastructure switch,
you should make sure data interfaces (management or dynamic interfaces) or AP−managers interfaces are
configured for these uplinked physical ports. Physical Ethernet ports which are used as an uplink to an infra
switch should not be left un−configured. This may result in unexpected behaviors.
Multicast unicast is not a supported configuration on Cisco 2500 Series Wireless Controller. As a result,
HREAP APs are not able to receive multicast traffic because HREAP APs only work with multicast unicast.
Related Information
Cisco Wireless LAN Controller Configuration Guide, Release 7.0.116.0•
Technical Support & Documentation − Cisco Systems•
Contacts & Feedback | Help | Site Map
© 2012 − 2013 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.
Updated: Jun 23, 2011 Document ID: 113034

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English