Cisco 2500 Series Deployment Guide

One more DHCP scope is configured on the controller. This configured DHCP Scope TestVlan11 is mapped
to the dynamic−interface configured on the controller.
<CISCO2504> >show dhcp summary
Scope Name Enabled Address Range
TestVlan10 Yes 10.10.10.100 −> 10.10.10.200
TestVlan11 Yes 10.10.11.100 −> 10.10.11.200
<CISCO2504> >show dhcp detailed TestVlan11
Scope: TestVlan10
Enabled................................... Yes
Lease Time................................ 36400 <10 hours 6 minutes 40 seconds>
Pool Start................................ 10.10.11.100
Pool End.................................. 10.10.11.200
Network................................... 10.10.11.0
Netmask................................... 255.255.255.0
Default Routers........................... 10.10.11.10 0.0.0.0 0.0.0.0
DNS Domain................................
DNS....................................... 0.0.0.0 0.0.0.0 0.0.0.0
Netbios Name Servers...................... 0.0.0.0 0.0.0.0 0.0.0.0
<CISCO2504> >
Internal DHCP Server with DHCP Proxy Enabled
By default, the DHCP Proxy is enabled on the controller as seen in one of the previous captures. Dynamic
interface dynamic11 is configured and is mapped to VLAN11. The interface is also mapped to the configured
internal DHCP server. The dynamic interface is not enabled for dynamic AP management.

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English