Cisco 6841 Administration Guide

Cisco IP Phone 6861 Multiplatform Phones don't support the Activation Code Onboarding feature.
Note
Before you begin
Ensure that you allow the activation.webex.com service through your firewall to support onboarding via
activation code.
Access the phone administration web page. See Access the Phone Web Page, on page 92.
Procedure
Step 1 Reset the phone to the factory settings.
Step 2 Select Voice > Provisioning > Configuration Profile.
Step 3 Enter the profile rule in the Profile Rule field in this format: gds://
Step 4 Select Firmware Upgrade.
Step 5 Enter the upgrade rule in the Upgrade Rule field in this format: http://<server ip
address>/sip88xx.11-2-3MSR1-1.loads/
Step 6 Submit All Changes.
See below a sample cfg.xml file showing the profile rule, and upgrade rule.
<?xml version="1.0" encoding="UTF-8"?>
<device>
<flat-profile>
<!-- System Configuration -->
<Profile_Rule ua="na">gds://</Profile_Rule>
<!-- Firmware Upgrade -->
<Upgrade_Enable ua="na">Yes</Upgrade_Enable>
<Upgrade_Error_Retry_Delay ua="na">3600</Upgrade_Error_Retry_Delay>
<Upgrade_Rule ua="na">http://<server ip address>/sip88xx.11-2-3MSR1-1.loads</Upgrade_Rule>
<!-- <BACKUP_ACS_Password ua="na"/> -->
</flat-profile>
</device>
Configure the Network from the Phone
The phone includes many configurable network settings that you may need to modify before it is functional
for your users. You can access these setting through the phone menus.
The Network configuration menu provides you with options to view and configure a variety of network
settings.
You can configure settings that are display-only on the phone in your Third-Party Call Control system.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
38
Phone Installation
Configure the Network from the Phone

Cisco 6841 Specifications

General

Brand	Cisco
Model	6841
Category	IP Phone
Language	English