Cisco 6841 Administration Guide

Procedure
Step 1 Select Voice > SIP.
Step 2 In the RTP Parameters section, set the Real-Time Transport Protocol (RTP) parameter values as described
in RTP Parameters, on page 237.
Step 3 Click Submit All Changes.
Configure the SDP Payload Types
Configured dynamic payloads are used for outbound calls only when the Cisco IP Phone presents a Session
Description Protocol (SDP) offer. For inbound calls with an SDP offer, the phone follows the caller’s assigned
dynamic payload type.
The Cisco IP Phone uses the configured codec names in outbound SDP. For incoming SDP with standard
payload types of 0-95, the phone ignores the codec names. For dynamic payload types, the phone identifies
the codec by the configured codec names (comparison is case-sensitive).
Before you begin
Access the phone administration web page. See Access the Phone Web Page, on page 92.
Procedure
Step 1 Select Voice > SIP.
Step 2 In the SDP Payload Types section, set the value as specified in SDP Payload Types, on page 238.
• AVT Dynamic Payload—Any nonstandard data. Both sender and receiver must agree on a number.
Ranges from 96 to 127. Default: 101.
Step 3 Click Submit All Changes.
Configure the SIP Settings for Extensions
Before you begin
Access the phone administration web page. See Access the Phone Web Page, on page 92.
Procedure
Step 1 Select Voice > Ext(n), where n is an extension number.
Step 2 In the SIP Settings section, set the parameter values as described in SIP Settings, on page 277.
Step 3 Click Submit All Changes.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
70
Phone Installation
Configure the SDP Payload Types

Cisco 6841 Specifications

General

Brand	Cisco
Model	6841
Category	IP Phone
Language	English