Procedure
Step 1 Select Voice > System.
Step 2 Set the Wi-Fi Settings fields as described in the Wi-Fi Settings, on page 229 table.
Connect the Phone to a Wi-Fi Manually
When you set up a Wi-Fi profile, it provides you the options to connect the phone manually to a wireless
network. You can establish the connection from the Wi-Fi profile screen or from the Setup Wi-Fi screen.
The top most Wi-Fi profile in the Wi-Fi profile screen gets connected automatically when the phone provisions.
Before you begin
• Turn on the Wi-Fi of your phone.
• Disconnect your phone with the wired network.
Procedure
Step 1 Press Applications .
Step 2 Select Network configuration > Wi-Fi configuration > Wi-Fi profile.
Step 3 In the Wi-Fi profile screen, do any of the actions to connect to Wi-Fi.
• Select any of the configured Wi-Fi profile and click Connect.
• Press Scan and select one wireless in the Connect to Wi-Fi screen. In the Setup Wi-Fi screen, enter
values in the fields and press Connect.
See the Profile Parameter table in the Set Up a Wi-Fi Profile from the Phone, on page 48 for the field values.
You can also configure the Wi-Fi settings using the configuration file.
<!-- Wi-Fi Settings -->
<Phone-wifi-on ua="rw">Yes</Phone-wifi-on>
<Phone-wifi-type ua="na">WLAN</Phone-wifi-type>
<!-- available options: WLAN|WPS -->
<!-- Wi-Fi Profile 1 -->
<Network_Name_1_ ua="rw">AP_SSID</Network_Name_1_>
<Security_Mode_1_ ua="rw">Auto</Security_Mode_1_>
<!--
available options: Auto|EAP-FAST|PEAP-GTC|PEAP-MSCHAPV2|PSK|WEP|None
-->
<Wi-Fi_User_ID_1_ ua="rw">User_ID</Wi-Fi_User_ID_1_>
<!--
<Wi-Fi_Password_1_ ua="rw">Password</Wi-Fi_Password_1_>
-->
<!-- <WEP_Key_1_ ua="rw"/> -->
<!-- <PSK_Passphrase_1_ ua="rw"/> -->
<Frequency_Band_1_ ua="rw">Auto</Frequency_Band_1_>
<!-- available options: Auto|2.4 GHz|5 GHz -->
<Wi-Fi_Profile_Order_1_ ua="rw">1</Wi-Fi_Profile_Order_1_>
<!-- available options: 1|2|3|4 --><!-- Wi-Fi Profile 2 -->
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
46
Phone Installation
Connect the Phone to a Wi-Fi Manually