Cisco 7600 Series Guide

vii
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-04
Preface
This guide describes the route switch processors and supervisor engines supported by Cisco 7600 series
routers. It also provides technical specifications for these modules and describes cable and connector
specifications.
Caution Only trained and qualified service personnel (as defined in IEC 60950 and AS/NZS3260) should install,
replace, or service the equipment described in this document.
Contents
This preface contains the following sections:
• Document History, page vii
• Document Organization, page viii
• Document Conventions, page viii
• Related Documentation, page ix
• Obtaining Documentation, Obtaining Support, and Security Guidelines, page x
Document History
Table 1 lists the technical changes made to this document since it was first printed.
Ta b l e 1 Document History
Revision Date Change Summary
OL-10100-04 January 2008 Added information about the Route Switch Processor 720 with
10-GE uplink ports, introduced in Cisco IOS Release 12.2SRC.
OL-10100-03 May 2007 Removed eFSU from the list of unsupported features for the Route
Switch Processor
720. Beginning in Cisco IOS Release 12.2SRB1,
eFSU and ISSU are supported on the RSP720, Sup720, and Sup32.
Added a note that Cisco IOS Release 12.2SXF is the last release in
which the Supervisor Engine 720 (with PFC3A) is supported.

Cisco 7600 Series Specifications

General

Brand	Cisco
Model	7600 Series
Category	Network Router
Language	English