ASN Call Procedure Flows â–€
Cisco ASR 5000 Series Product Overview â–„
the MS NAI and MS IP address of the subscriber, since the authenticator, DHCP and PMIP functions are not exposed
here and the MSID is used as the username in session manager. The non-anchor session has the following attributes:
The Registration Type in the request is set to HO.
The Destination ID in the message does not match the destination IP address of the message. It needs to match
the anchor ASN Gateway ID in the message if an R6 and R4 Data Path setup is intended.
The anchor ASN Gateway is one of the peer ASN Gateway configured in the ASN Gateway service.
Initial Network Entry and Data Path Establishment without Authentication
This section describes the procedure of initial entry and data session establishment for a WiMAX subscriber station (SS)
or MS without authentication by ASN Gateway.
To Next Page
Loading...
Need help?
General
