Figure 219: Rotating the Ejector Levers Inward to Seat the Version 2 Power Tray
Step 3 Install the captive screw in each ejector lever into the screw hole in the power tray frame (figures Rotating
the Ejector Levers Inward to Seat the Version 1 Power Tray or Rotating the Ejector Levers Inward to Seat
the Version 2 Power Tray).
Step 4 Use the 6-inch long number 2 Phillips screwdriver to tighten the two ejector screws to a torque of 10 +/-1
in-lb to secure the ejectors and to secure the tray to its mating connector.
Step 5 Install and tighten two screws through the power tray mounting ears on each side into the screw holes in the
chassis mounting ears to secure the tray to the chassis.
Removing and Replacing Cards from the Chassis
This section describes the procedures for removing and installing an RSP card, RP card, FC, or LC.
See the Cisco ASR 9000 Series Aggregation Services Router SIP and SPA Hardware Installation Guide for
information about removing and installing SIP and SPA cards.
• For a information about the router components and slot numbering for the Cisco ASR 9010 Router, Cisco
ASR 9006 Router, and Cisco ASR 9904 Router, see Removing RSP Cards and Line Cards from the
Cisco ASR 9006, 9010, 9904, 9906, and 9910 Routers.
• For a information about the router components and slot numbering for the Cisco ASR 9922 Router and
Cisco ASR 9912 Router, see Removing RP Cards, Fabric Cards, and Line Cards from the Cisco ASR
9922 Router and Cisco ASR 9912 Router.
• The Cisco ASR 9906 and Cisco ASR 9910 chassis are midplane chassis and the method of removal and
replacing cards is different from other routers. The RSP (RSP0, RSP1) cards are located in the front of
the chassis. The 4 line cards on the Cisco ASR 9906 (LC0 - LC3) and 8 line cards on the Cisco ASR
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
245
Replacing Cisco ASR 9000 Series Router Components
Removing and Replacing Cards from the Chassis
To Next Page
Loading...
Need help?
General
