Node 0/RSP0/CPU0 is in ACTIVE role
Node Redundancy Partner (0/RSP1/CPU0) is in STANDBY role
Standby node in 0/RSP1/CPU0 is ready
Standby node in 0/RSP1/CPU0 is NSR-not-configured
Node 0/RSP0/CPU0 is in process group PRIMARY role
Process Redundancy Partner (0/RSP1/CPU0) is in BACKUP role
Backup node in 0/RSP1/CPU0 is ready
Backup node in 0/RSP1/CPU0 is NSR-ready
Group Primary Backup Status
--------- --------- --------- ---------
dsc 0/RSP0/CPU0 0/RSP1/CPU0 Ready
dlrsc 0/RSP0/CPU0 0/RSP1/CPU0 Ready
central-services 0/RSP0/CPU0 0/RSP1/CPU0 Ready
v4-routing 0/RSP0/CPU0 0/RSP1/CPU0 Ready
netmgmt 0/RSP0/CPU0 0/RSP1/CPU0 Ready
mcast-routing 0/RSP0/CPU0 0/RSP1/CPU0 Ready
v6-routing 0/RSP0/CPU0 0/RSP1/CPU0 Ready
Router# show platform
Node Type State Config State
-----------------------------------------------------------------------------
0/RSP0/CPU0 A9K-RSP880-LT-TR(Active) IOS XR RUN PWR,NSHUT,MON
0/RSP1/CPU0 A9K-RSP880-LT-TR(Standby) IOS XR RUN PWR,NSHUT,MON
0/0/CPU0 A99-8X100GE-TR IOS XR RUN PWR,NSHUT,MON
0/2/CPU0 A99-12X100GE IOS XR RUN PWR,NSHUT,MON
0/3/CPU0 A99-8X100GE-TR IOS XR RUN PWR,NSHUT,MON
Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card
Before you begin:
• You must have console access to the router. Default console speed on RSP5 is set as 115200.
• The router must be running Cisco 64-bit IOS XR software release 6.5.15 or later version. If your router
is running a 32-bit IOS XR release, you will need to migrate to 64-bit XR release 6.5.15 or later. Refer
to Migration Guide for Cisco ASR 9000 Series Routers.
RSP5 is only supported with 64-bit IOS XR software releases.
Note
• The router must have two RSP4/S/L cards (active and standby) up and running. In this section, RSP
refers to RSP4/RSP4-S/RSP4-L in the system.
• First and second generation Cisco ASR 9000 Ethernet Line Cards must be removed from the chassis as
they are incompatible with RSP5.
Procedure
Step 1 Use the show redundancy summary command to verify that the RSP0 and RSP1 are in Ready State.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
258
Replacing Cisco ASR 9000 Series Router Components
Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card
To Next Page
Loading...
Need help?
General
