PurposeCommand or Action
Example:
Router# show interface
Gigabitethernet0/0/1 rep detail
(Optional) Saves your entries in the router startup configuration file.copy running-config startup-config
Example:
Router# copy running-config
startup-config
Step 10
Setting the Preemption for VLAN Load Balancing
To set the preemption for VLAN load balancing, complete these steps on the router that has the segment with
the primary edge port.
Restrictions
If you do not enter the rep preempt delay seconds command on the primary edge port to configure a preemption
time delay, the default is to manually trigger VLAN load balancing on the segment. Use the show rep topology
command to see which port in the segment is the primary edge port.
Before You Begin
Be sure that all other segment configurations have been completed before setting the preemption for VLAN
load balancing. When you enter the rep preempt segment segment-id command, a confirmation message
appears before the command is executed because preemption for VLAN load balancing can disrupt the network.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
rep preempt segment segment-id
4.
end
5.
show rep topology
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
LAN Switching Configuration Guide Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
24
Configuring Resilient Ethernet Protocol
Setting the Preemption for VLAN Load Balancing
To Next Page
Loading...
Need help?
General
