Cisco ASR-920-4SZ-A User Manual

Enabling UDLD Probe Message Interval
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
udld message time interval
4.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Set the time in seconds between UDLD probe messages. The
valid range is from 7 to 90 seconds. The default is 15 seconds
udld message time interval
Example:
Router(config)# udld message time 90
Step 3
Returns to privileged EXEC mode.end
Example:
Router# end
Step 4
Recovering the UDLD Protocol
UDLD recovery when enabled, attempts to bring an UDLD error-disabled port out of reset. Tthe default
recovery timer is 300 seconds.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
udld recovery inteval
4.
end
LAN Switching Configuration Guide Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
42
UniDirectional Link Detection (UDLD) Protocol
Enabling UDLD Probe Message Interval

Cisco ASR-920-4SZ-A Specifications

General

Brand	Cisco
Model	ASR-920-4SZ-A
Category	Network Router
Language	English