Figure 30: Guiding the Cables through the Guard
Step 6 (Optional) To attach the cable guard to the desk or wall, use a 0.144-inch (3.7 mm) or a #27 drill bit to drill
1/2-inch (12.7 mm) holes at each of the two mounting locations. Insert the supplied 0.5 in. (12.7 mm) number-8
Phillips wood screws and tighten them.
Figure 31: Securing the Cable Guard to the Desk
Desk or shelf2Number-8 Phillips wood
screws
1
Installing SFP Modules
See the switch release notes on Cisco.com for the list of supported SFP modules. Use only Cisco SFP modules
on the switch. Each Cisco module has an internal serial EEPROM that is encoded with security information.
This encoding provides a way for Cisco to identify and validate that the module meets the requirements for
the switch.
For information about installing, removing, cabling, and troubleshooting SFP modules, see the module
documentation that shipped with your device.
Cisco Catalyst 1000 Series 8-Port and 16-Port Switch Hardware Installation Guide
35
Switch Installation
Installing SFP Modules
To Next Page
Loading...
Need help?
General