Step 5 (Optional) Use the small sleeve for thin power cords. Use the small sleeve to provide greater stability for thin
cords. Detach the sleeve, and slide it over the power cord.
Figure 17: Sleeve Around the Power Cord
AC power cord2Sleeve for thin power
cords
1
Step 6 Secure the AC power cord by pressing on the retainer.
Figure 18: Securing the Power Cord in the Retainer
Installing SFP Modules
See the switch release notes on Cisco.com for the list of supported SFP modules. Use only Cisco SFP modules
on the switch. Each Cisco module has an internal serial EEPROM that is encoded with security information.
This encoding provides a way for Cisco to identify and validate that the module meets the requirements for
the switch.
For information about installing, removing, cabling, and troubleshooting SFP modules, see the module
documentation that shipped with your device.
Installing an SFP or SFP+ Module
Before you begin
When installing SFP or SFP+ modules, observe these guidelines:
Cisco Catalyst 1000 Series 24-Port and 48-Port Switch Hardware Installation Guide
27
Switch Installation
Installing SFP Modules
To Next Page
Loading...
Need help?
General