Cisco Catalyst 2900 Series Hardware Installation Guide

Chapter 1 Overview
Key Features
1-2
Catalyst 2900 Series XL Modules Hardware Installation Guide
78-5912-03
Note To use the ISL and IEEE 802.1Q trunking features, you must enable
them by using the Enterprise Edition Software. These features
cannot be used with the standard edition software.
Key Features
Table 1-1 describes the module features in detail.
Model Number
1
1. If you insert these modules into a Catalyst 2912MF XL (WS-C2912MF-XL) or
Catalyst 2924M XL switch (WS-C2924M-XL-A or WS-C2924M-XL-EN), they support up to
8192 MAC addresses on each switch. If you insert any of these modules into a
Catalyst 2916M XL switch (WS-C2916M-XL), they support up to 2048 MAC addresses on each
switch.
Description
WS-X2914-XL-V 4 autosensing 10/100 UTP ports
WS-X2922-XL-V 2 100BaseFX ports
WS-X2932-XL 1 1000BaseT port
WS-X2924-XL-V 4 100BaseFX ports
WS-X2931-XL 1 1000BaseX port
Table 1-1 Catalyst 2900 Series XL Modules Features
Module Feature
WS-X2931-XL
(1 1000BaseX port)
WS-X2932-XL
(1 1000BaseT port)
• Hot-swappable
• Management through an SNMP management station, the Cisco IOS
command-line interface (CLI), or the web-based Visual Switch Manager
(VSM)
• Autonegotiation of duplex mode and flow control
• IEEE 802.1Q VLAN trunk support
• ISL trunk support
• Up to 8192 MAC addresses on each modular switch

Cisco Catalyst 2900 Series Specifications

General

Brand	Cisco
Model	Catalyst 2900 Series
Category	Switch
Language	English