Cisco Catalyst 2960-XR Reference

debug platform stack-manager
To enable debugging of the stack manager software, use the debug platform stack-manager command in
privileged EXEC mode. To disable debugging, use the no form of this command.
debug platform stack-manager {all| rpc| sdp| sim| ssm| tdm| trace}
no debug platform stack-manager {all| rpc| sdp| sim| ssm| tdm| trace}
Syntax Description
Displays all stack manager debug messages.all
Displays stack manager remote procedure call (RPC) usage debug messages.rpc
Displays the Stack Discovery Protocol (SDP) debug messages.sdp
Displays the stack information module debug messages.sim
Displays the stack state-machine debug messages.ssm
Displays the stack manager topology discovery use debug messages.tdm
Traces the stack manager entry and exit debug messages.trace
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX1
Usage Guidelines
This command is supported only on stacking-capable switches.
The undebug platform stack-manager command is the same as the no debug platform stack-manager
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable debugging
on a stack member, you can start a session from the stack master by using the session switch-number EXEC
command. Enter the debug command at the command-line prompt of the stack member. You also can use
the remote command stack-member-number LINE EXEC command on the stack master switch to enable
debugging on a member switch without first starting a session.
Catalyst 2960-XR Switch Stack Manager Command Reference, Cisco IOS Release 15.0(2)EX1
OL-29435-01 15
Stack Manager Commands
debug platform stack-manager

Cisco Catalyst 2960-XR Specifications

General

Brand	Cisco
Model	Catalyst 2960-XR
Category	Switch
Language	English