Cisco Catalyst 2960-XR Reference

reload
To reload the stack member and to apply a configuration change, use the reload command in privileged EXEC
mode.
reload [/noverify| /verify] [LINE| at| cancel| in| slot stack-member-number| standby-cpu]
Syntax Description
(Optional) Specifies to not verify the file signature before the reload./noverify
(Optional) Verifies the file signature before the reload./verify
(Optional) Reason for the reload.
LINE
(Optional) Specifies the time in hh:mm for the reload to occur.at
(Optional) Cancels the pending reload.cancel
(Optional) Specifies a time interval for reloads to occur.in
(Optional) Saves the changes on the specified stack member and then
restarts it.
slot
(Optional) Stack member number on which to save the changes. The
range is 1 to 8.
stack-member-number
(Optional) Reloads the standby route processor (RP).standby-cpu
Command Default
Immediately reloads the stack member and puts a configuration change into effect.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX1
Usage Guidelines
If there is more than one switch in the switch stack, and you enter the reload slot stack-member-number
command, you are not prompted to save the configuration.
Examples
This example shows how to reload the switch stack:
Switch# reload
System configuration has been modified. Save? [yes/no]: y
Catalyst 2960-XR Switch Stack Manager Command Reference, Cisco IOS Release 15.0(2)EX1
OL-29435-01 17
Stack Manager Commands
reload

Cisco Catalyst 2960-XR Specifications

General

Brand	Cisco
Model	Catalyst 2960-XR
Category	Switch
Language	English