Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact
with such circuits, because they may cause serious injury or death. For proper installation and grounding of
the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code,
Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Warning
This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory
compliance and legal requirements may apply for direct connection to the Cable Distribution System. This
product may connect to the Cable Distribution System ONLY through a device that is approved for direct
connection. Statement 1078
Warning
A minimum of -1 inch clearance is required on all sides of the product when mounting in either horizontal or
vertical orientation. Stacking heat-dissipating objects on top of the router is not allowed. I/O side clearance
is needed because it is required to access the cable connections. Clearance is required to attach, mount the
DIN rail bracket, and Wall mount bracket.
Note
Equipment, Tools, and Connections
This section describes the equipment, tools, and connections necessary for installing your Cisco IR1800.
By default, no antenna is shipped with the IR1800 Series router.
Note
Items Shipped with Your Router
Unpack the box and verify that all the items listed in the invoice are shipped with the Cisco IR1800.
The following items are shipped with your router:
• Pointer Card
• Grounding Lug Kit
• Power Connector
Additional Items
The following items are not shipped with the router, but are required for the installation:
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
26
Installing the Router
Equipment, Tools, and Connections
To Next Page
Loading...
Need help?
General
