Cisco IE 3000 Getting Started Guide

Cisco IE 3000 Switch Getting Started Guide
12
Cisco IE 3000 Switch Getting Started Guide
OL-16234-01
• Attaching the Power and Relay Connector, page 20
• Optional Procedures, page 21
Equipment That You Supply
Obtain these necessary tools and equipment:
• Ratcheting torque flathead screwdriver that exerts up to 15-inch pound (in-lb)
of pressure
• Ring terminal lug (such as Thomas & Bett part number 10RC6 or equivalent)
• Crimping tool (such as Thomas & Bett part number WT2000, ERG-2001, or
equivalent)
• 10- to 12-gauge copper ground wire (such as Belden part number 9912 or
equivalent)
• For DC power connections, use UL- and CSA-rated style 1007 or 1569
twisted-pair copper appliance wiring material (AWM) wire (such as Belden
part number 9318)
• Wire-stripping tools for stripping 10-, 12-, and 18-gauge wires
• For rack-mounting, a number-2 Phillips screwdriver
• A flat-blade screwdriver
Before You Begin
When you determine where to install the switch, verify that these guidelines
are met:
• Operating environment is within the range in the switch hardware installation
guide.
• Clearance to front and rear panels meets these conditions:
– Front-panel LEDs can be easily read.
– Access to ports is sufficient for unrestricted cabling.
– Front-panel direct current (DC) power and relay connector is within
reach of the connection to the DC power source.

Cisco IE 3000 Specifications

General

Brand	Cisco
Model	IE 3000
Category	Switch
Language	English