EasyManuals Logo
Home>Cisco>Network Router>IR829

Cisco IR829 User Manual

Cisco IR829
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
11
Getting started with the Cisco 829 Integrated Services Router
78-100611-01A0
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotopically radiated power (EIRP) is not more than that permitted for successful
communication.
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems.
Users are advised that high-power radars are allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to
LE-LAN devices.
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Cisco® 829 Industrial Integrated Services Router PIDS
IR829GW-LTE-VZ-AK9
IR829GW-LTE-NA-AK9
IR829GW-LTE-ST-AK9
Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive
93/42/EEC
The following standards were applied:
EMC-EN 301.489-1 v1.9.2; EN 301.489-17 v2.2.1
Health & Safety-EN60950-1: 2005; EN 50385: 2002
Radio-EN 300 328 v 1.9.1; EN 301.893 v 1.7.1, EN62311
The conformity assessment procedure referred to in Article 10.4 and Annex III of Directive 1999/5/EC
has been followed.
This device also conforms to the EMC requirements of the Medical Devices Directive 93/42/EEC.
Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to
certain frequencies and/or may require a license for operation. For more details, contact Cisco Corporate
Compliance.
The product carries the CE Mark:
Declaration of Conformity for RF Exposure
This section contains information on compliance with guidelines related to RF exposure.
Generic Discussion on RF Exposure
The Cisco products are designed to comply with the following national and international standards on
Human Exposure to Radio Frequencies:
US 47 Code of Federal Regulations Part 2 Subpart J
American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers /
IEEE C 95.1 (99)

Table of Contents

Other manuals for Cisco IR829

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IR829 and is the answer not in the manual?

Cisco IR829 Specifications

General IconGeneral
BrandCisco
ModelIR829
CategoryNetwork Router
LanguageEnglish

Related product manuals