Linksys E-Series.
Advanced Configuration.
Setup > Basic Setup
Language
The first screen that appears is the Basic Setup screen. This allows you to change
Select your language
To use a different language, select one from the drop-
the router’s general settings.
down menu. The language of the browser-based utility will change five seconds
after you select another language.
Internet Setup
The Internet Setup section configures the router to your Internet connection.
Most of this information can be obtained through your Internet Service
Provider (ISP).
Internet Connection Type
Select the type of Internet connection your ISP provides from the drop-down
menu. The available types are:.
•. Automatic Configuration - DHCP.
•. Static IP.
•. PPPoE.
•. PPTP.
•. L2TP.
•. Telstra Cable.
Automatic Configuration - DHCP
The default Internet Connection Type is Automatic Configuration - DHCP
(Dynamic Host Configuration Protocol). Keep the default only if your ISP
supports DHCP or if you connect using a dynamic IP address. (This option
usually applies to cable connections.).
Static IP
If you are required to use a fixed IP address to connect to the Internet, select
Static IP
PPPoE
If you have a DSL connection, check whether your ISP uses Point-to-Point
Protocol over Ethernet (PPPoE) If so, select PPPoE.
5
To Next Page
Loading...
Need help?
General
