18
Chapter 5: Connecting the Wireless-B Media Adapter to Your TV and Stereo
Overview
Wireless-B Media Adapter
Chapter 5: Connecting the Wireless-B Media Adapter to Your
TV and Stereo
Overview
This chapter will explain what to do if you used the Setup Wizard to set up the Adapter and what to do if you want
to set up the Adapter from your TV.
If you used the Setup Wizard, then follow the instructions to disconnect the Adapter from your network, connect
the Adapter to your TV (and stereo, if you have one), and re-connect the Adapter to your network. (You have to
disconnect the Adapter from your network in order to move it to your TV and stereo.)
If you want to set up the Adapter from your TV, then go directly to the “Connecting to Your TV and Stereo” section
if you have a stereo. Go directly to the “Connecting to Your TV Only” section if you do not have a stereo.
Instructions
1. Press the Adapter’s power button on its front panel to power it off.
2. Unplug the power adapter from the Adapter’s Power port and electrical outlet. See Figure 5-1.
3. If you used a wired computer to set up the Adapter, then unplug the Ethernet network cable from the
Adapter’s LAN port and the Ethernet (LAN) port of your PC, router, or switch.
4. Move the Adapter and its power adapter to the TV.
5. If you have a stereo, go to the “Connecting to Your TV and Stereo” section.
If you do not have a stereo, go to the “Connecting to Your TV Only” section.
Figure 5-1: Unplug the Power
Note: Make sure you keep the PC you were using powered on because it will communicate with the
Adapter and send music and pictures.
To Next Page
Loading...
Need help?
General