CHAPTER
2-15
Cisco MDS 9148S Multilayer Switch Hardware Installation Guide
OL-20185-01
2
Installing the Cisco MDS 9148S Switch
This chapter describes how to install the MDS 9148S switch and its components, and it includes the
following information:
• Preinstallation, page 2-16
• Front-Facing Installation, page 2-19
• Installing the Switch in a Cabinet with Insufficient Front Clearance, page 2-21
• Grounding the Switch, page 2-26
• Grounding the Switch, page 2-26
• Starting Up the Switch, page 2-27
• Removing and Installing Components, page 2-29
Note Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for the Cisco MDS 9000 Family for important safety information.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. Use the statement number provided at
the end of each warning to locate its translation in the translated safety warnings that
accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service
this equipment.
Statement 1030
To Next Page
Loading...
Need help?
General