Cisco MX200 Series User Manual

34
D1458217 User Guide Cisco TelePresence
Prole Series, Codec C-series, Quick Set C20
SX20 Quick Set, MX200, MX300
Produced: November 2013 for TC7.0
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.
The maximum number of participants
in a Multiway conference depends
entirely on the video infrastructure
implemented in your organization. If
in doubt, consult your Video Support
Team.
If you want to initiate a video
conference, you must call each
participant one by one.
Call settings. Those you call may
have video systems with dierent
capabilities. One of them may, for
example, be on an ADSL system
with limited bandwidth (compared
to the others). You may then set the
Call settings to a (normally lower)
call rate (bandwidth) suiting his
or her system before you call that
person. However, that call rate will
aect that specic part of the video
conference only. Other participants
will not suer from a lower call rate
because of this.
Video conferencing
Calling more than one using Multiway or CUCM
This is an optional feature that may, or may not, be installed on your system.
About Multiway/CUCM
Assume that
you already are in
a call. This call may
have been initiated
by you or by someone else
(someone have called you).
Tap Add.
Locate whom to call.
Place the call in the
usual way.
Tap Merge to create
a conference, as
outlined.
It may take a short while to
create the conference.
To add more participants repeat
the procedure. The maximum
number of participants depends on
your video system infrastructure.
If in doubt consult your Video
Support Team.
If you initiated the conference you
will be able to terminate the entire
conference as well. The other
participants, however, may only
disconnect themselves from the
conference.

Cisco MX200 Series Specifications

General

Brand	Cisco
Model	MX200 Series
Category	Conference System
Language	English