D1458217 User Guide Cisco TelePresence
Prole Series, Codec C-series, Quick Set C20
SX20 Quick Set, MX200, MX300
Produced: November 2013 for TC7.0
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.
Video conferencing
Controlling the camera of one of the other participants
Within video conferencing the term
far end is often used to refer to the
one you are talking to.
Far end is an ambiguous term in
video conferencing, since there is
more than just one far end.
Consequently, you must start by
dening whose camera you are
going to control.
Once you have dened this, the
procedure is identical to the one
explained in “Controlling the camera
of the other participant” on page
28.
The ability to control a far end
camera requires that the far
end system camera is remotely
adjustable. The feature cannot be
applied to systems with a manual
camera adjustment.
You will not have access to any
presets that may exist on the far end
video system.
About camera control
Tap the participant
whose camera you
want to control.
Then tap Camera, as outlined.
This will invoke the Camera
control dialog box, whose use
is explained in “Controlling
the camera of the other
participant” on page 28.
To Next Page
Loading...
Need help?
General
