D1458217 User Guide Cisco TelePresence
Prole Series, Codec C-series, Quick Set C20
SX20 Quick Set, MX200, MX300
Produced: November 2013 for TC7.0
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.
This is a convenient way to obtain
information about all the participants
and their current status.
In addition, you may use the list
to disconnect participants from
the conference or to grant them
certain rights, such as to retain the
position as prominent speaker even
if someone else starts speaking.
These features are outlined on the
following pages.
Using the list
Video conferencing
Invoking a list of participants and their status
The list will show who is
presenting (how to conduct
presentations is outlined in
the following chapter of this
document), who is speaking
and if someone has been put
on hold, that will be indicated
too.
Swipe towards left or tap the
other dot to return to the initial
state.
In a call, swipe your
nger horizontally
to the left, as
outlined...
...or tap the
little dot not
shown in
white, as
outlined.
To Next Page
Loading...
Need help?
General
