Cisco MX300 G2 User Manual

10
D1507602 User Guide
Cisco TelePresence MX200 G2, MX300 G2
SX80
Produced: April 2014 for TC 7.1
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.
Tap Dial, as outlined,
to invoke the numerical
dialpad.
Tap Keyboard
(
), as outlined
to invoke the virtual
keyboard.
Key in the name.
Matches will appear as
you type.
There is an extended
numerical mode
available, which also
contains special
characters.
To toggle between the
alphanumerical mode
and the extended
numerical mode tap the key in the
lower left corner of the keyboard, as
outlined.
When you are
ready to place the
call, tap the green
Call button.
Place Call Using Name
About Placing Calls
You may call someone who is not
listed in your list of contacts by
keying in their name, address or
number using the virtual keyboard of
the Touch pad.
Anyone you have previously called
will appear in the Recents list (until
you clear that list) and you may then
transfer any of them to your list of
Favorites. This is described in the
section Contacts.
Calling extensions. Sometimes
you may be urged to enter numbers
during a call, typically to reach
extensions or to provide a pin code.
Tap Keypad (this button appears as
soon as the call is placed) to invoke
the keypad needed for this.
Place Call

Cisco MX300 G2 Specifications

General

Brand	Cisco
Model	MX300 G2
Category	Conference System
Language	English