Cisco MX300 G2 User Manual

72
D1507602 User Guide
Cisco TelePresence MX200 G2, MX300 G2
SX80
Produced: April 2014 for TC 7.1
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.
You may gain access to your video
system through its web interface, see
the Administration Guide for more.
From the web interface you may gen-
erate snapshots of the video stream
from your system. You may also
generate snapshots from the outgoing
video of the far end system.
However, you cannot take snapshots
unless you have set the Allow Web
Snapshots to ON, as shown here.
Snapshots cannot be taken if the call is
encrypted. Encryption will disable the
snapshot feature at both ends, regard-
less of the local settings of the Allow
Web Snapshots parameter.
The web snapshot feature applies to
Point-to-Point as well as MultiSite calls
(but to unencrypted calls only).
In this context a MultiWay call should
be regarded as a variant of Point-
to-Point call as it is the MCU who is
controlling the call and your system is
connected to the MCU as in a Point-
to-Point call.
Caution! There is no Cancel function
letting you exit the menu undoing any
changes you have made. Take care!
Settings
Administrator Settings—Web Snapshots
About Snapshots
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!
Note! Using your video system’s web interface you may
take snapshots of the video stream from your system by
setting Allow Web Snapshots to On.
Observe that the far end may take snapshots of the
outgoing video of your system, even if you have set your
own Allow Web Snapshots to OFF.
Likewise, you may take snapshots of the outgoing video
of the far end, even if the far end has set Allow Web
Snapshots to OFF, provided that you have set your own
system’s Allow Web Snapshots to ON.

Cisco MX300 G2 Specifications

General

Brand	Cisco
Model	MX300 G2
Category	Conference System
Language	English