Cisco RV260P User Manual

8 Cisco RV260P Router Quick Start Guide
Troubleshoot Your Connection
If you cannot access your device by using the Setup Wizard, the device
may not be reachable from your computer. You can test network
connections by using ping on a computer running Windows:
STEP 1 Open a command window by using Start > Run and enter cmd.
STEP 2 At the Command window prompt, enter ping and the device IP
address. For example, ping 192.168.1.1 (the default static IP
address of the device).
If you can reach the device, you should get a reply similar to the
following:
Pinging 192.168.1.1 with 32 bytes of data:
Reply from 192.168.1.1: bytes=32 time<1ms TTL=128
If you cannot reach the device, you should get a reply similar to the
following:
Pinging 192.168.1.1 with 32 bytes of data:
Request timed out.
Possible Causes and Resolutions
Bad Ethernet connection:
Check the LEDs for the proper indications. Check the connectors of the
Ethernet cable to ensure that they are firmly plugged into the device
and your computer.
Wrong or conflicting IP address:
Verify that you are using the correct IP address of the device.
Verify that no other device is using the same IP address as this device.
No IP route:
If the device and your computer are in different IP subnetworks,
remote access must be enabled and you need at least one router on
the network to route the packets between the two subnetworks.
Unusually long access time:
Adding new connections may take 30 – 60 seconds for the affected
interfaces and LAN to become operational.

Cisco RV260P Specifications

General

DHCP client	Yes
Routing protocols	RIP-1, RIP-2, RIPng
Supported protocols	PPPoE, PPTP, IGMP, RSTP, DynDNS, No-IP, ChangeIP, NAT, PAT
IPv4 & IPv6 features	Dual stack IPv4/IPv6
Link layer protocols	L2TP
DSL WAN	No
VPN support	Client-to-gateway IPsec VPN, IPsec VPN, PPTP VPN, OpenVPN, VPN pass-through
Firewall security	SPI firewall, Port forwarding and triggering, Denial-of-Service prevention (DoS)
Security algorithms	3DES, 128-bit AES, 192-bit AES, 256-bit AES, HTTPS, IPSec
VPN tunnels quantity	20
Throughput	0.8 Gbit/s
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.1p, IEEE 802.1x
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
Safety	UL 60950-1, CAN/CSA-C22.2 No. 60950-1, IEC 60950-1, EN 60950-1, FCC Part 15.247, 15.407, RSS-210, EN 300.328, EN 301.893, AS/NZS 4268.2003, FCC Part 15.107, FCC Part 15.109, ICES-003, EN 301.489-1, EN 301.489-17
Operating system installed	Linux
Product color	Black
LED indicators	LAN, Power, WAN
Combo SFP ports quantity	1
Ethernet LAN (RJ-45) ports	8
Power over Ethernet (PoE) ports quantity	4
Input current	1.67 A
Output voltage	54 V
Power source type	DC, PoE
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %
Package type	Box
Package depth	261 mm
Package width	435 mm
Package height	106 mm
Package weight	2720 g

Weight and Dimensions

Depth	170 mm
Width	279.4 mm
Height	38.5 mm
Weight	1260 g